Throwback Thursday Styling Tip this week will be focused on how to create custom glued hairline on a

Throwback Thursday Styling Tip this week will be focused on how to create custom glued hairline on a wig from scratch. Now, I know there are tons of glued hairline tutorials out there, but I do it a little differently and I found it to produce a pretty realistic result without the hairline “floating” problem. The wig in this pic is a cheap wig I bought to style into a Kurogane (Tsubasa: Reservoir Chronicle) wig. I used the same hairline technique to create extremely unique-shaped hairlines for the Vegeta (DBZ) wig and Yusuke (Yu Yu Hakusho) wig as well. Using this technique is easier to get accurate custom hairline which is very difficult to replicate with a lacefront wig, especially if you don’t know how to hand-ventilate hair.- On the inside of the wig, glue a strip of clear vinyl fabric on with Fabri-Tac glue. Hold until it completely dries. I chose to use clear vinyl because it’s waterproof and can be shaped with heat from the hairdryer if need to. Since it’s waterproof, when you wear the wig and apply spirit gum to glue down the inside of the hairline to your forehead area, it will stick better and is easier to clean off the residue later.- Pin the wig on a foam head. Use a marker that’s close in color to your wig and mark the hairline shape you want. You may want to do the marking while trying the wig on to make sure it works for your forehead shape. Cut off the excess vinyl outside the marked area. If you need the vinyl to be larger for more extreme hairline, you can cut in darts and Fabri-Tac glue it so it’s more curved to your forehead shape, and not pointing out straight.- Mix craft glue and water in a cup. I used Elmer’s clear glue. You can use regular Elmer’s glue or school glue, but I find the clear Elmer’s glue to be best for dark colored wigs. Mixing ratio of glue to water is 3:1. Make sure to not use too much water, you want a syrup-like texture after you mix it with a paint brush.- Cut a small piece of hair from loose wefts. Point-cut into the tip of the hair piece to create varying points and thin out the tip.- Brush on the water-downed glue to the tip of the hair piece on both sides. I don’t go above one inch from the tip. Use your finger to squeeze the glue on the hair to help spread it through all layers and to help flatten the piece.- It should look flat and pointy after it dries. You can make a lot of pieces like this and set them to dry on a big plastic bag. I make about 30-40 of these hair pieces for a normal wig’s hairline. It is time-consuming but the result is worth it!- Next, put a thin layer of Fabri-Tac glue on the back of the hair piece. Press down the hair piece to the clear vinyl in the center. Fabri-Tac takes longer to dry than hot glue but it’s more permanent and won’t cause the hair piece to be bulky.- Continue the same step as the last. Make sure to position the hair piece so that the tips go a bit past the clear vinyl. This will help cover the seams and hide the vinyl in the process.- And you’re done! Enjoy fabulous hairline. Make sure to research how to apply and remove spirit gum before wearing the wig. -- source link

More pics about