caffeinatedcrafting:Worbla Tutorial - Fold Over vs SandwichCountless people have posted tutorials wi
caffeinatedcrafting:Worbla Tutorial - Fold Over vs SandwichCountless people have posted tutorials with far more knowledge than I have. What I’m hoping to show with this and a series of other quick worbla tutorials I’ll be posting is show what it’s like working with thermoplastic when you have little experience and highlighting some of the pitfalls you’ll likely encounter along the way.When putting worbla over foam to make armor, you can apply it in one of two ways, you can either cut one piece and fold the edges over, which leaves the back side as raw foam. Or you can use two pieces of worbla and sandwich the foam in-between.Steps for Both:- Cut out your worbla piece(s) with extra around the edges to accommodate for the fold over- Using a hairdryer or heat gun to heat up the piece of worbla, press and pat the flexible worbla until it adheres to the foamSteps for Fold Over:- Along the edges make sure you trim pieces off so you get nice uniform folds anywhere you are folding past a corner- Re-heat as necessary, much easier to cut pieces off when its still flexableSteps for Sandwich:- Make sure you start with the rear piece first, you could run into problems with your seaming if you start with the front- Make sure that the edges of the rear piece remain hot/flexible as you apply the front- Trim the excess off the edges, reheat as necessary, cut as close to the foam as possible and smooth/flatten the seam.Fold Over Pros:- Uses Less Worbla- Front part will look just as good as sandwichCons:- Unable to restick to other worbla pieces as there is nothing on the back- Exposed back pieces may be visible in photosSandwich Pros:- Smoother finish- Can ‘stick’ to other worbla partsCons:- Uses double the worbla- Can be difficult to keep everything heated and flexible depending on the pieceOverall I think there is a place for each of them, though I’m more partial to the sandwich method. Using that method you can also heat strips of worbla and use them to hold down elastic or O-rings that you’d use to attach your armor parts later.The biggest pitfall to avoid no matter which method you use is to be very careful around the edges and get a nice smooth fold over or seam, Ill show you how to fix any issues with the edges in the next tutorial. -- source link
#cosplay tutorials#worbla#armor