hurtanminttu:Has anyone had an issue with Intuous that the pressure sensitivity works randomly on
hurtanminttu: Has anyone had an issue with Intuous that the pressure sensitivity works randomly on the pen but fine on the eraser end? The sensitivity just… is randomly sensitive (see pic, all same motion but the sensitivity registers or cuts off how it wants sometimes), and I updated driver/disabled Win10 Ink as I could/changed the nib. And when I look at the Wacom Tablet Properties, I see that often the pressure jumps right into 50%, which in turn means that normal taps do nothing and thus clicking anything is a pain. Might something be broken in the pen, since the “eraser end” of it is fine? I don’t recall if an update happened before this started, but I’ve never had this issue before at least. Update, thanks for all the suggestions and help! I contacted the Wacom Support and it would seem that this is an issue of a broken stylus, so I’m copypasting the response in here incase someone else has the exact same issue:If the pen stroke is not continuous you can perform the following tests:- open the driver (Wacom Tablet Properties) then About and Diagnose..: see if when you apply pressure on the nib the pressure reading “jumps” or is continuousalso- open a canvas at full screen in a drawing application- draw parallel lines ½ inch apart on the whole surface of the tablet both horizontal and verticalIf the pressure reading is not consistent then the pen has an issue with the pressure sensor.If the canvas has jagged lines or “holes” then the issue is with the tablet. -- source link